Identification of product

Check the identification data on the product nameplate. The nameplate is located at the same end of the unit as the inlet connections. The product nameplate includes contact information of the manufacturer, product designation, number of order acknowledgement, technical data of the fan motor, operating/test pressure, min/max operating temperature, internal volume, weight, month/year of manufacture and (if required) CE or EAC marking. CE marking is available for SR™ models on request.

Product labels

Table 1. Product labels
Centre of gravity

When lifting the unit with a forklift, always place the forks under the centre of gravity.

Product nameplate
Model See Equipment description
O.A.

Order Acknowledgement number

Serial no: Ref Communicate these when ordering spare parts as they identify the unit
Unit net weight Check weight before any lifting operation to ensure that proper lifting tools are used
Coil data
Material Tube material
Volume Internal volume
Fluid group According to PED
max DN Maximum diameter of the distributor tube
Coil TS Range of operating temperatures for the coil
PS Design pressure
PT Test pressure
Test date: Date on which the factory has pressure tested the coil
Fan direction

Fan rotation direction (IEC-fan packages)

Electrical warning

Electrically powered component. Switch off power supply before any maintenance or installation operation

Hot surface warning
Lifting points

H-position lifting

In/out

Fluid connections inlet and outlet

Eurovent

Product is included in Eurovent Certify all program (only units where applicable)

Pressure tested
Do not step over the header

Do not lift from the header

Only for transportation

Remove components with this sticker before installing the cooler

Operation notes
Low Temperature circuit (only for two circuit models)

Identifies the Low Temperature circuit

High Temperature circuit (only for two circuit models)

Identifies the High Temperature circuit

Option: EC cabinet

Wait 5 min before opening

Option: Cabinet delivered with frequency converter

Wait 15 min before opening.

Never turn the switch by-pass when the motors are running

Models according to air flow direction (induced fans)

SM/SRM™ narrow coil single fan row unit is on the left. SD/SRD™ wide coil units in dual fan row is in the middle and single fan row on the right.

Figure: AlfaSolar S/SR™ series, vertical air flow

SM/SRM™ narrow coil single fan row unit is on the left. SD/SRD™ wide coil units in dual fan row is in the middle and single fan row on the right.

Figure: AlfaSolar S/SR™ series, horizontal air flow

Models with forced draught fans (option-FD) according to air flow direction

Note: These models are only available for the industrial AlfaSolar SR™ series.

SM/SRM™ narrow coil single fan row unit is on the left. SD/SRD™ wide coil units in dual fan row is on the right.

Figure: AlfaSolar SR™ series FD models, vertical air flow

SM/SRM™ narrow coil single fan row unit is on the left. SD/SRD™ wide coil units in dual fan row is on the right.

Figure: AlfaSolar SR™ series FD models, horizontal air flow